Installation Procedure

Turn off engine and other electrical devices.
 

Open the car hood and locate the battery. (In some cars the battery may not be located inside the engine compartment.)
 

Loosen the battery's negative terminal, attach the negative contact of the Nanopulser (the black wire) and then firmly retighten the battery terminal. Now loosen the battery's positive terminal, attach the positive contact of the Nanopulser (the red wire) and then firmly retighten the battery terminal. If you cannot insert the Nanopulser contacts this way, attach them with enclosed self-tapping screws to the battery terminals.

*Dirty battery terminals could corrode the contacts and wires that can cause faulty connections. If the terminals are dirty, clean them with sandpaper or a wire brush.

*Attach by loosening the terminal bolt. Be careful, because detaching wired cords could delete the memory of devices such as clocks and radios.

*After installing Nanopulser, make sure that all the terminals are firmly tightened. To protect against corrosion, apply grease.
 

Place the Nanopulser on a flat surface or on top of the battery using the double-sided tape. Be sure to wipe the surface clean first.

Be sure to position the Nanopulser so it does not touch the hood when the hood is down.
 

Check the green LED light to confirm that Nanopulser is energized and working fine.
 

Excessive wire should be bundled together for safety.

 

♦When using a battery, use caution for following points for your safety.
 

• Using a battery near fire could cause an explosion.

• Ventilation is very important to avoid hydrogen and oxygen gas from igniting and exploding.

• Children and adults who are not familiar with handling of a batteries should not handle them. Explosion could cause serious burns and possible blindness.

• Wear goggles and rubber gloves when handling batteries. Contact with electrolyte could cause burns and blindness.

• When installing a battery in a car, be sure the positive and negative terminals are correct. Wrong connection could damage the electronic devices of the car.

• Do not use a dry cloth to clean batteries. Static discharge could ignite gases and cause explosion.

*Consult manual of the battery for other safety warnings.
 

Download Your Nanopulser Brochure Here